This study aimed to investigate biomechanical properties of synthetic implants for reconstructive surgery of pelvic floor dysfunction. In this dissertation, we chose four synthetic implants, i.e. total pelvic floor repair system (PROLIFT), gynecone TVT obtutator system (TVT-O), intra-vaginal sling placement device (IVS) and acellular dermal matrix (Renov), for tensile test respectively. The biomechanical properties of four synthetic implants were measured and analyzed using a material testing machine (Instron 4302 versatile material testing machine). The biomechanical parameters included ultimate stress strength, modulus of elasticity, maximum load and maximum elongation. The results showed that the maximum load of the four symthetic implants was TVT-O > IVS > PROLIFT > Renov, and the maximum load of TVT-O was significantly higher than PROLIFT and Renov ( P < 0.05). The ultimate stress strength was TVT-O > IVS > PROLIFT > Renov, with no significant differences among them ( P > 0.05). The maximum elongation of the four implants was TVT-O > PROLIFT > IVS > Renov, and the maximum elongation of TVT-O and PROLIFT were both significantly higher than Renov ( P < 0.05). The modulus of elasticity was IVS > Renov > TVT-O > PROLIFT, with no significant differences among them ( P > 0.05). Taken together, the present study demonstrates that the modulus of elasticity of IVS was the highest in the four synthetic implants; TVT-O had the highest mechanical strength; The maximum load, ultimate stress strength and maximum elongation of Renov were all the lowest; The mechanical properties of PROLIFT was the most stable, and its modulus of elasticity was the lowest in the four synthetic implants, which had good extensibility and elasticity. Therefore, it is necessary to pay attention to the biomechanical properties of new pelvic reconstructive materials for the clinical pelvic reconstructive surgery.
【摘要】 目的 研究千伏级锥形束CT（kV-cone beam CT，kV-CBCT）影像用于鼻咽癌调强放射治疗计划剂量计算的可行性和精确度。 方法 2010年7-9月7例鼻咽癌患者 ，获取每例患者的第1天放射治疗时的kV-CBCT影像。用CIRS062密度模体和患者自身特定区域亨氏单位值（hounsfield unit，HU）映射的两种方法重新刻度亨氏单位值-相对电子密度（HU-RED）表，分别进行剂量计算，并与在传统扇形束CT（FBCT）影像上的原放射治疗计划结果进行对比，包括辐射剂量分布、靶区和危及器官的剂量体积直方图（DVH）。 结果 kV-CBCT影像的治疗计划和原治疗计划在剂量分布和DVH上有较好的一致性。在剂量分布的比较上采用了γ分析（2%/2 mm标准的通过率），用基于模体的HU-RED表得到的治疗计划与原治疗计划对比，在经过等中心冠状面、矢状面和横断面的通过率分别为92.7%±3.5%、95.1%±3.1%和95.7%±3.4%，用基于患者的HU-RED表得到治疗计划与原治疗计划对比的通过率分别为94.8%±2.7%、96.6%±2.9%和97.4%±2.7%。DVH的统计数据表明，两种方法得到的kV-CBCT治疗计划和原治疗计划相比较，靶区和危及器官剂量偏差大多数在2%以内。有1例因在横断面发生了明显的旋转误差，导致在横断面的通过率很低，DVH统计数据较原计划偏差较大。 结论 kV-CBCT影像可以用来做辐射剂量计算，基于患者自身影像生成的HU-RED表的治疗计划较原治疗计划有更高的符合度。【Abstract】 Objective To evaluate the feasibility and accuracy of dose calculation based on cone beam CT (CBCT) data sets for intensity modulated radiation therapy (IMRT) planning of nasopharyngeal cancer (NPC). Methods Seven NPC patients were selected. The kV-CBCT images for each patient were acquired on the first treatment day. Two correction strategies were used to generate the cone beam HU value vs relative electron density calibration tables which named CIRS062 phantom based HU-RED tables and patient specific HU-RED tables respectively for dose calculation. The dose distributions and dose volume histograms (DVHs) of the target and organs at risk (OAR) based on kV-CBCT images were compared to the plans based on the fan-beam CT (FBCT). Results The DVH and dose distribution comparison between plans based on the FBCT and those on the CBCT showed good agreements. The γ analysis with a criterion of 2 mm/2% was used for the comparison of dose distribution at the coronal plane, sagital plane and cross plane through the isocenter point. The passing rate from phantom based HU-RED tables were (92.7±3.5) %, (95.1±3.1) %, and (95.7±3.4)%, respectively. The passing rates from the patient specific HU-RED tables were (94.8±2.7) %, (96.6±2.9) %, and (97.4±2.7) %, respectively. The dose difference between plans based on CBCT and those based on FBCT was within 2% at most patients by analyzing DVH based parameters. Only one patient who had significant rotation setup error resulted in the low passing rate and disagreement in DVH. Conclusion The CBCT images can be used to do dose calculation in IMRT planning of NPC. The differences between plans based on HU-RED tables generated by specific patient and the original plans are less than those between plans based on CIRS062 phantom based HU-RED tables and the original plans.