Using LabVIEW programming and highspeed multifunction data acquisition card PCI6251, we designed an electrocardiogram (ECG) signal generator based on Chinese typical ECG database. When the ECG signals are given off by the generator, the generator can also display the ECG information annotations at the same time, including waveform data and diagnostic results. It could be a useful assisting tool of ECG automatic diagnose instruments.
M+N theory can be used as a method to improve the prediction accuracy in spectral analysis. The measured component, M kinds of non-measurement component, and N kinds of outside interference are induced into the entire measuring system, with the impact of "M" factors and "N" factors on the measurement accuracy considered systematically and comprehensively. Our human experiment system testing blood oxygen saturation based on "M+N" theory has been established. Dynamic spectrum method was used to eliminate the effects of different persons and different measuring parts which belonged to the system error of "N" factors. And then the D-value estimation was used to eliminate the effects of motion pseudo signal which belonged to the random error of "M" factors. Sixty two groups of valid data were obtained. The prediction model of blood oxygen saturation was built based on partial least squares regression method. The correlation coefficient and relative error were 0.796 8 and ±0.026 6, while the result of oximeter was 0.595 7 and relative error was ±0.076 0, respectively. The results show that the prediction accuracy of the measurement method based on the "M+N" theory is much higher than that of the oximeter.
Electric and electronic products are required to pass through the certification on electrical safety performance before entering into the market in order to reduce electrical shock and electrical fire so as to protect the safety of people and property. The leakage current is the most important factor in testing the electrical safety performance and the test theory is based on the perception current effect and threshold. The traditional method testing the current threshold for perception only depends on the sensing of the human body and is affected by psychological factors. Some authors filter the effect of subjective sensation by using physiological and psychological statistical algorithm in recent years and the reliability and consistency of the experiment data are improved. We established an experiment system of testing the human body's current threshold for perception based on EEG feature analysis, and obtained 967 groups of data. We used wavelet packet analysis to detect α wave from EEG, and used FFT to do spectral analysis on α wave before and after the current flew through the human body. The study has shown that about 97.72% α wave energy changes significantly when electrical stimulation occurs. It is well proved that when the EEG feature identification is applied to test the human body current threshold for perception, and meanwhile α wave energy change and human body sensing are used together to confirm if the current flowing through the human body reaches the perception threshold, the measurement of the human body current threshold for perception could be carried out objectively and accurately.