It is one of the priorities of the new round of healthcare reform to develop regional healthcare alliances through vertically integrating resources. This paper reviews the framework and characteristics of Shanghai’s healthcare system, and then analyzes its strengths and weaknesses, underscoring Shanghai’s exploration in the vertical integration of medical resources as a response to the pressing issues in healthcare. The paper outlines the main tasks and groundwork of the Shanghai healthcare alliance initiative and gives an outlook on the expected outcomes. It ends with some thoughts on the problems and challenges confronting regional healthcare alliances in Shanghai.
Objective To provide basis for cl inical appl ication of ANKYLOS dental implants by following up alveolar bone status of 318 pieces of restored ANKYLOS dental implants. Methods Between February 2008 and August 2009, 170 patients with dentition defect underwent placement of ANKYLOS dental implants (318 pieces). There were 74 males (133 pieces) and 96 females (185 pieces) with an average age of 43.8 years (range, 23-68 years). After operation, the periapicalX-ray films were taken to observe osseointegration around the neck of implant, alveolar bone resorption, and survival ofimplants. Results All patients were followed up at 6, 12, and 24 months after operation. There were 9 failure implants witha total dental implants survival rate of 97.17% (309/318): 3 at 6 months, 4 at 6-12 months, and 2 at 12-24 months, showing no significant difference in dental implants survival rate among 3 time points (χ2=0.470 3, P=0.492 8). New bone formed around the neck of implant in 4 cases at 6 months and in 31 cases at 12 months; at 6, 12, and 24 months, the bone increase was (0.392 7 ± 0.217 4), (0.633 5 ± 0.202 1), and (0.709 0 ± 0.199 1) mm, respectively, showing significant differences among 3 time points (P lt; 0.05). At 6, 12, and 24 months after operation, the bone loss of other patients was (0.392 7 ± 0.217 4), (0.716 7 ± 0.220 3), and (0.723 2 ± 0.215 4) mm, respectively, showing significant differences among 3 time points (P lt; 0.05). Conclusion After restoration with ANKYLOS dental implant, alveolar bone status is good and the implant success rate is high during short-term follow-up. But further observation and study are required for long-term effectivness.
Objective To evaluate the effect of the local del ivery of basic fibroblast growth factor 2 (bFGF-2) on the osseointegration around titanium implant of diabetic rats. Methods The bFGF-2-loaded poly (lactic-co-glycol ic acid) microspheres were prepared by water/oil/water (W/O/W) double-emulsion solvent evaporation method. Thirty-five male SPF level Sprague Dawley rats, weighing 220-250 g and aged 9 weeks, were selected as experimental animals. Ten rats were fedwith the routine diet as normal control group. The other 25 rats were made the diabetic animal model by giving high fat-sugar diet and a low dose streptozotocin (30 mg/ kg) intravenously; 20 rats were made the diabetic animal model successfully. Then 20 rats were randomly divided into diabetic control group (n=10) and bFGF-2 intervention group (n=10). A hole was drilled in the right tibia bone of all rats, and the titanium implant treated by micro-arc oxidation surface was planted into the hole. Simultaneously, the previously prepared microspheres and blood were mixed and were loaded on the surface of the implant before it was implanted into the rats of the bFGF-2 intervention group. At 4 and 8 weeks, the tibia containing implants was harvested, embedded with resin and made undecalcified tissue sl ices to compare the osseointegration. Results At 4 weeks, the implants of the normal control group were surrounded by new lamellar bone with continuity; whereas the tissue around the implants of the diabetic control group contained l ittle woven bone and some fibrous tissue; and obvious new formed bone with continuity was observed in bFGF-2 intervention group. At 8 weeks, the results of 3 groups were similar to those at 4 weeks. At 4 weeks, the percentage of bone-implant contact (BIC) in diabetic control group was significantly less than those in normal control group (P lt; 0.05) and in bFGF-2 intervention group (P lt; 0.05); the BIC in bFGF-2 intervention group was less than in normal control group, but showing no significant difference (P gt; 0.05). After 8 weeks, the BIC in normal control group and in bFGF-2 intervention group were significantly greater than that in diabetic control group (P lt; 0.05), but there was no significant difference between bFGF-2 intervention group and normal control group (P gt; 0.05). Conclusion Local del ivery of bFGF-2 around titanium implants may improve the osseointegration in diabetic rats.
ObjectiveTo observe the effect of sensory integration training combined with methylphenidate hydrochloride on attention deficit hyperactivity disorder (ADHD). MethodsThe clinical data of 96 patients with ADHD diagnosed between January 2009 and March 2013 were retrospectively analyzed. The patients were divided into two groups by the table of random number. The trail group (n=48) received the combination therapy of sensory integration training combined with methylphenidate hydrochloride; while the control group (n=48) only received the medication of methylphenidate hydrochloride. The scores of sensory integration ability rating scale, integrated visual and auditory continuous performance test (IVA-CPT), Conner's behavior rating scale, Chinese Wechsler Intelligence Scale for Children (C-WISC) and adverse reactions were observed and compared between the two groups. ResultsThe scores of the sensory integration ability rating scale, FRCQ, FAQ (IVA-CPT), PIQ, VIQ, FIQ, C factor (C-WISC) in both of the two groups were significantly higher after the therapy; while the scores of the study, behavior, somatopsychic disturbance, impulsion, hyperactivity index and anxiety factor significantly decreased after the treatment (P<0.05). Compared with the control group, the trial group's scores of sensory integration ability rating scale, IVA-CPT, Conner's behavior rating scale, C-WISC were improved obviously, and the adverse reactions were significantly less (P<0.05). ConclusionThe sensory integration training combined with methylphenidate hydrochloride is sage and effective on children with attention deficit hyperactivity disorder.
ObjectiveTo evaluate the infiuence of doctor-nurse double check table applied before operation on the completion of preoperative preparation in gastrointestinal surgery department of class-three grade-one hospitals. MethodsA total of 647 selective operation patients from April to September 2013 in the Department of Gastrointestinal Surgery were divided into observation group (n=315) and control group (n=332) based on admission time. After training for medical staff, the check tables were filled, and relatively high frequency issues were followed up for quality tracking. The completion of preoperative preparation was compared between the two groups after operation. ResultsCompared with the control group, the completion of preoperative preparation and satisfaction of patients of the observation group were significantly higher and the operation delay was significantly lower (P<0.05). ConclusionPreoperative application of doctor-nurse double check table can significantly improve the completion rate of preoperative preparation, the operation delay phenomenon and satisfaction of patients, promote the communication between doctors and nurses, reduce the risk of operation, and ensure the safety of surgical patients.
Integrating medical instruments with medical information systems becomes more and more important in healthcare industry. To make medical instruments without standard communication interface possess the capability of interoperating and sharing information with medical information systems, we developed a medical instrument integration gateway based on Integrating the Healthcare Enterprise Patient Care Device (IHE PCD) integration profiles in this research. The core component is an integration engine which is implemented according to integration profiles and Health Level Seven (HL7) messages defined in IHE PCD. Working with instrument specific Javascripts, the engine transforms medical instrument data into HL7 ORU message. This research enables medical instruments to interoperate and exchange medical data with information systems in a standardized way, and is valuable for medical instrument integration, especially for traditional instruments.
Integration of heterogeneous systems is the key to hospital information construction due to complexity of the healthcare environment. Currently, during the process of healthcare information system integration, people participating in integration project usually communicate by free-format document, which impairs the efficiency and adaptability of integration. A method utilizing business process model and notation (BPMN) to model integration requirement and automatically transforming it to executable integration configuration was proposed in this paper. Based on the method, a tool was developed to model integration requirement and transform it to integration configuration. In addition, an integration case in radiology scenario was used to verify the method.
Medical information exchange and integration is the effective method to solve the interoperability and medical information island, and is the basis of medical information sharing. In this paper, we take medical texts and medical images as the basic integrated objects, DICOM, HL7 messages and datasets as the integrated units, efficient DICOM, HL7 message construction and parsing methods as basis, design and realize a universal medical information integration and exchange service middleware. Experimental results show that the prototype system could perform medical information integration and exchange among relational database, HL7 and DICOM message, provide a feasible scheme to solve the medical information island and lay a good foundation for establishing the unified medical information integration and sharing platform. The middleware has been applied in the project named "development and demonstration of opened medical information integration system".
This paper aims to utilize the intersecting cortical model (ICM), which imitates the biological neural cells sync pulse, to preliminary research about the contour integration mechanism and the selection of attention. The idea of "Excitement-Inhibition" oscillation is introduced into the ICM, and meanwhile, the target contour chain code is used as the high-level feedback to control the input. Thus, we propose the Excitation-Inhibition-ICM which contains both the BUTTON-UP and the TOP-DOWN mechanism. The experimental results showed that the proposed model could effectively suppress noise to make the smooth edge synchronization issue, thus completing the process of BOTTOM-UP. The introduction of the target contour chain code can obtain consistent target outline with the input target chain code, but other targets cannot form a closed contour since they do not match with the input target chain code, so as to realize the TOP-DOWN mechanism. The results proved that our proposed model could imitate the contour integration mechanism and the selection of attention of the visual cortex V1.
Objective To analyze the distribution of stress in the upper and lower plates of the prosthesis-bone interface, and the effect of interface pressure on osseointegration. Methods CT scanning was performed on goats at 1 week after artificial cervical disc replacement to establish the finite element model of C3, 4. The stress distribution of the upper and lower plates of the interface was observed. At 6 and 12 months after replacement, Micro-CT scan and three dimensional reconstruction were performed to measure the bone volume fraction (BVF), trabecular number (Tb. N), trabecular thickness (Tb. Th), trabecular separation (Tb. Sp), bone mineral density (BMD), bone surface/bone volume (BS/BV), and trabecular pattern factor (Tb. Pf). The C3 lower plate and C4 upper plate of 4 normal goat were chosen to made the cylinder of the diameter of 2 mm. The gene expressions of receptor activator for nuclear factor κB ligand (RANKL), osteoprotegerin (OPG), transforming growth factor β (TGF-β), and macrophage colony-stimulating factor (M-CSF) were detected by real time fluorescent quantitative PCR at immediate after cutting and at 24 and 48 hours after culture. The samples of appropriate culture time were selected to made mechanical loading, and the gene expressions of RANKL, OPG, M-CSF, and TGF-β were detected by real time fluorescent quantitative PCR; no mechanical loading samples were used as normal controls. Results Under 25 N axial loading, the stress of the upper plate of C3, 4 was concentrated to post median region, and the stress of the lower plate to middle-front region and two orbits. According to stress, the plate was divided into 5 regions. The Micro-CT scan showed that BMD, Tb.Th, BVF, and Tb.N significantly increased, and BS/BV, Tb.Sp, and Tb.Pf significantly decreased at 12 months after replacement when compared with ones at 6 months (P<0.05). At 24 and 48 hours after culture, the gene expressions of RANKL, OPG, and TGF-β were signifi-cantly higher than those at immediate (P<0.05), but no significant difference was found between at 24 and 48 hours after culture (P>0.05). The mechanical loading test results at 24 hours after culture showed that the RANKL and OPG gene expressions and OPG/RANKL ratio in C3 lower plate and C4 upper plate were significantly up-regulated when compared with controls (P<0.05), but no significant difference was shown in TGF-β and M-CSF gene expressions (P>0.05). Conclusion Domestic artificial cervical disc endplate has different pressure distribution, the stress of lower plate is higher than that of upper plate. Pressure has important effect on local osseointegration; the higher pressure area is, the osseointegration is better. Under the maximum pressure in interface, the osteoblast proliferation will increase, which is advantageous to the local osseointegration.